|
The
sensor fits onto the gear lever replacing the original
toe pedal. The direction of the gearshift pattern can
be switched in seconds by rotating the sensor through
180 degrees.
|
|
|
|
The
sensor has a single black wire which connects to the control
box. A 6mm threaded hole is used to bolt the sensor to
the lever.
|
|
After
drilling a 6mm hole and counter boring, the countersink
screw cant be seen. The wire can then be tie wrapped or
bonded to the back of the lever arm.
|
|
|
|
Sensitivity
adjustment is made using a 1.5mm allen key(supplied).
Clockwise = increase sensitivity.
|
Spot
the wire! On a good installation the sensor wire can
be hard to find.
|
 |
